THE COURSE / M1 THE SWITCH / M1.7
FinFET to nanosheet
After this lesson you can:
- Explain why a thin body with the gate on more sides stops short-channel leakage.
- Work out a FinFET's width from its fins, and say why nanosheets followed.
- Say what the nanosheet adds to the flow, and what CFET stacks next.
Loading the lesson…
Sources
- C. C. Hu, Modern Semiconductor Devices for Integrated Circuits (Pearson, 2010), chapter 7, "MOSFETs in ICs—Scaling, Leakage, and Other Topics" (free from the author). Gate oxide thinned from 300 nm at the 10 µm technology to 1.2 nm at 65 nm, roughly in proportion to the line width, to raise the on-current and to control Vt roll-off as the channel shortens. Below 1.5 nm, tunnelling leakage limits it: 1.2 nm of SiO₂ leaks 10³ A/cm², 10 A from 1 mm² of gate, enough to drain a phone's battery in minutes; nitrogen cuts it about tenfold. HfO₂ has k ≈ 24, six times SiO₂'s: 6 nm of HfO₂ gives the capacitance of 1 nm of SiO₂ (an EOT of 1 nm) with leakage several orders of magnitude lower; a thin SiO₂ interfacial layer under it; metal gates, two metals for N and P transistors. SiO₂ breakdown about 7 MV/cm for ten years' operation. Below threshold the current falls exponentially, by ten for every S = η × 60 mV at room temperature (η ≥ 1; e.g. 90 mV at η = 1.5): the subthreshold swing. Vt is defined where Ids = 100 nA × W/L (some companies 200 nA); Ioff, at Vgs = 0, = 100 nA × (W/L) × 10^(−Vt/S). An Ioff of 100 nA per transistor across a hundred million transistors is 10 A in standby. Vt can't be made arbitrarily small; S is lowered by a thinner oxide or a wider depletion layer. Vt rolls off as the channel shortens: short-channel transistors leak more. Moore (1965): devices per chip double every 18 to 24 months; each node shrinks features to 70%, halving the area of a circuit, every two to three years. Table 7–1 (history and ITRS projection): 90 nm (2003) Vdd 1.2 V, 65 nm 1.1, 45 nm 1.0, 32 nm 1.0, 22 nm (2013) 0.9 V; strained silicon from 90 nm, high-k/metal gate from 45 nm, immersion lithography at 32 nm, a new structure at 22 nm. Strain: SiGe grown in trenches beside a PFET's gate compresses its channel and raises hole mobility. Vt roll-off: in a short channel the drain lowers the source–channel barrier (drain-induced barrier lowering), so less gate voltage is needed; roll-off ∝ (Vds + 0.4 V) e^(−L/ld), ld ∝ (Toxe Wdep Xj)^(1/3); minimum L several times ld. Even with a thin oxide the drain controls leakage paths below the surface, far from the gate: ultra-thin bodies and multigate transistors remove them. Random dopant fluctuation: the number and place of dopant atoms in a small transistor varies, and with it Vt. Designers get two or three Vts to choose from.
- Intel, "Intel Reinvents Transistors Using New 3-D Structure," press release, 4 May 2011 (as republished by ScienceDaily, 5 May 2011). For the first time since the invention of silicon transistors, 3-D transistors enter high-volume manufacturing: Tri-Gate, first disclosed in 2002, at the 22 nm node, first in the chip code-named Ivy Bridge. The planar gate is replaced by a thin silicon fin with a gate on each of its three sides, two on the sides and one across the top. Up to 37% faster at low voltage than Intel's 32 nm planar transistors, or less than half the power at the same performance.
- Q. Zhang, Y. Zhang, Y. Luo and H. Yin, "New structure transistors for advanced technology node CMOS ICs," National Science Review 11, nwae008 (2024). Stacked nanosheet transistors: about 80% of the flow shared with a gate-last FinFET, plus four new steps (sub-fin doping, Si/SiGe superlattice epitaxy, inner spacers, channel release); the superlattice grown below 650 °C; inner spacers of more than ten steps; SiGe removed at over 100:1; the sub-fin's leakage and bottom dielectric isolation; wider sheets for more current; the gate between the sheets. FinFETs used from the 22 nm node to 3 nm; fins grown thinner and taller bring reduced mobility, random doping fluctuation and Vt differences, and around 3 nm short-channel effects. GAA nanosheets: better electrostatics than FinFETs, more effective width from stacked sheets, and a broad allowable width for flexible design; Samsung's stacked three-sheet GAAFETs with 12 nm gates; an imec 2016 nanowire with a 24 nm gate reached 65 mV/decade and DIBL of 42 mV/V. Channel doping much reduced in FinFETs and GAAFETs. CFET stacks the n- and p-type transistors vertically, removing the n-to-p spacing, toward cells of four or even three tracks.
- TSMC, "2nm Technology" (logic technology page, read 28 October 2026). N2 features first-generation nanosheet transistor technology; it started volume production in 4Q25 as planned.