Skip to content

THE COURSE / M2 PURE SILICON / M2.8

Where the water goes

After this lesson you can:

  • Follow a wafer plant's used water through its six steps: kept apart by stream, neutralised, fluoride taken down, sludge pressed, some reused, the rest checked before the sea.
  • Explain why fluoride is taken down with lime in two stages, and why calcium fluoride's slight solubility leaves some fluoride behind.
  • Read an outfall's numbers against its limits, and say what happens when one is over.

Loading the lesson…

Sources

  1. SUMCO, サイトデータ (site data), 2025 figures (read 9 November 2026). Yearly maxima at the Kyushu office's Nagahama and Kubara plants: fluoride 3 mg/L at both against a limit of 8; suspended solids 13 and 10 mg/L against 30; COD 13 and 5 mg/L against 30. The page says COD applies to water discharged to the sea and BOD to rivers; both plants carry COD and no BOD, so they are regulated like sea dischargers (the page does not name where they discharge). Their published fluoride limit of 8 is stricter than the national 15 for the sea; the page does not say where the 8 comes from. The Kyushu office's Saga site carries BOD, with a fluoride limit of 3 and a maximum of 1.
  2. Ministry of the Environment, Japan, 一般排水基準 (uniform national effluent standards) (read 9 November 2026). Fluoride and its compounds: 8 mg F/L to waters other than the sea, 15 mg F/L to the sea. pH: 5.8 to 8.6 to waters other than the sea, 5.0 to 9.0 to the sea.
  3. SUMCO, 水資源の有効利用 (using water well) (read 9 November 2026). SUMCO's Japanese plants recycled 38.9% of their water in 2025. Rinse water from cleaning wafers is recovered; the reject water from making pure water cools utility equipment and dilutes wastewater treatment chemicals.
  4. SUMCO, CSR Report 2020 (Japanese) (read 9 November 2026). p. 30: dewatered sludge is much of the group's industrial waste; it cuts treatment chemical dosing and runs the dewatering machines to lower the sludge's water content; the Yonezawa plant sells its acid waste liquid (酸性廃液) to a firm that can recycle it.
  5. SUMCO, Sustainability Report 2023 (Japanese) (read 9 November 2026). p. 17: industrial waste recycling rate 82.9% in 2022, up from 77.2%. p. 52: a waste liquid concentrator brought in to cut sludge. p. 53: waste contractors' trucks checked so sludge and waste liquid don't fall from them.
  6. J. Lebeau and C. Maury (STMicroelectronics), "Defluoridation of waste water," US Patent 6,436,297 B1 (priority 28 November 1997, granted 20 August 2002). A chip maker's account of lime treatment: it reaches about 8 mg/L of fluoride in theory, and 17 to 24 mg/L is observed in practice; the basic neutralisation is generally done in two steps, with an excess of calcium kept; an acid neutralisation follows; flocculants are added to help the precipitate settle. The patent's own method reaches 8 to 11 mg/L.
  7. A. Sinharoy, G.-Y. Lee and C.-M. Chung, "Process Intensification for Enhanced Fluoride Removal and Recovery as Calcium Fluoride Using a Fluidized Bed Reactor," Int. J. Mol. Sci. 25, 4646 (2024). The semiconductor industry is a major source of fluoride wastewater, and hydrofluoric acid the fluoride chemical it uses most; precipitation with calcium hydroxide or chloride is common, but its sludge holds a lot of water and is hard to reuse; calcium fluoride's solubility limits removal. The paper's own two stages are fluidized-bed crystallisation reactors, not lime tanks, so it is not cited for two-stage lime.
  8. Wolfspeed: Industrial Facilities Wastewater Technician (Durham, NC; page shows posted 11/5/2026, read 9 November 2026), on career.com. At a silicon carbide wafer and device maker: runs the fluoride reduction process to keep within the discharge permit, neutralises mixed acids before discharge, recovers process water through multimedia and carbon filters and reverse osmosis, and calibrates pH and conductivity meters.