Skip to content

THE COURSE / M4 PATTERNING / M4.8

Strip and rework

After this lesson you can:

  • Say what a dry strip has to remove after an etch and after an implant, and what it must not touch.
  • Explain why implanted resist is hard to strip, and what "popping" is.
  • Say when a layer can still be reworked, and how the scanner is corrected for the next try.

Loading the lesson…

Sources

  1. D. Cheung et al. (Novellus Systems), "Ultra low silicon loss high dose implant strip," US patent 9,564,344 B2 (2017; priority 2009). High-dose implantation impregnates the resist and depletes its surface of hydrogen: a dense, carbonized, cross-linked crust, stripped 50% or 75% slower than the bulk below; the bulk can build pressure under it until the resist "pops", a source of particles; residues are common after stripping; even very little silicon loss from the source and drain can hurt the device; traditional strips use oxygen, these hydrogen.
  2. J. Lin, C. Wu and G. K. C. Huang (United Microelectronics), "Method and apparatus for forming patterned photoresist layer," US patent 7,033,903 B2 (2006). When the overlay of an exposed resist layer to the layer below is out of tolerance, the resist is removed for rework and a correction fed back to the exposure tool; the resist is formed, exposed and measured again. Measured only after development, a rework wastes the developer, and wafers processed before the correction arrives must be reworked too.