Skip to content

THE COURSE / M8 INTEGRATION / M8.1

One flow, front to back

After this lesson you can:

  • Name the parts of a chip's flow, the transistors, the contacts and the wiring, and what each makes.
  • Say which four steps a nanosheet flow adds to a FinFET's, and why the gate goes in last.
  • Place each of Fab B's steps in the flow, and name the module it comes from.

Loading the lesson…

Sources

  1. Q. Zhang, Y. Zhang, Y. Luo and H. Yin, "New structure transistors for advanced technology node CMOS ICs," National Science Review 11, nwae008 (2024). Stacked nanosheet transistors: about 80% of the flow shared with a gate-last FinFET, plus four new steps (sub-fin doping, Si/SiGe superlattice epitaxy, inner spacers, channel release); the superlattice grown below 650 °C; inner spacers of more than ten steps; SiGe removed at over 100:1; the sub-fin's leakage and bottom dielectric isolation; wider sheets for more current; the gate between the sheets. FinFETs used from the 22 nm node to 3 nm; fins grown thinner and taller bring reduced mobility, random doping fluctuation and Vt differences, and around 3 nm short-channel effects. GAA nanosheets: better electrostatics than FinFETs, more effective width from stacked sheets, and a broad allowable width for flexible design; Samsung's stacked three-sheet GAAFETs with 12 nm gates; an imec 2016 nanowire with a 24 nm gate reached 65 mV/decade and DIBL of 42 mV/V. Channel doping much reduced in FinFETs and GAAFETs. CFET stacks the n- and p-type transistors vertically, removing the n-to-p spacing, toward cells of four or even three tracks.
  2. B. W. Ku, P. Debacker, D. Milojevic, P. Raghavan, D. Verkest, A. Thean and S. K. Lim, "Physical design solutions to tackle FEOL/BEOL degradation in gate-level monolithic 3D ICs," ISLPED 2016. With copper wiring below, later processing must stay under 450 °C, or copper diffuses into the low-k insulator.