Skip to content

THE COURSE / M8 INTEGRATION / M8.6

Power from the back: the bond

After this lesson you can:

  • Explain why power is moving from the front-side wiring to the back of the wafer.
  • Say what has to be planned from the start, and why the wafer is bonded to a carrier before anything else.
  • Tell fusion bonding from hybrid bonding, and say which the backside route uses.

Loading the lesson…

Sources

  1. imec, "Imec demonstrates critical building blocks for a backside power delivery network" (10 June 2021). Power delivered from the back: a Si/SiGe stack grown first, its SiGe an etch stop; the front built; the wafer flipped and bonded face down to a carrier; the back thinned to the SiGe, which is removed; tungsten nano-TSVs and backside metal; final silicon 20 to 370 nm thick; it largely reduces the IR drop from rising wiring resistance.
  2. EV Group, "Hybrid and Fusion Bonding" (technology page, read 25 October 2026). Fusion, or direct, bonding joins dielectric layers on each wafer: activated surfaces pre-bond at room temperature through hydrogen bridge bonds, and an anneal turns them covalent. Hybrid bonding adds metal pads in the interface for face-to-face electrical connection, as in stacked image sensors, memory and 3D systems-on-chip.
  3. B. W. Ku, P. Debacker, D. Milojevic, P. Raghavan, D. Verkest, A. Thean and S. K. Lim, "Physical design solutions to tackle FEOL/BEOL degradation in gate-level monolithic 3D ICs," ISLPED 2016. With copper wiring below, later processing must stay under 450 °C, or copper diffuses into the low-k insulator.